- Once the styler is switched on it will automatically start heating up to 160°C.
- There are 3 temperature settings 160°C, 170°C and 180°C which are indicated by the LEDs as shown below.
- To select the temperature setting press the on/off button once, twice or three times.
- The LEDs will flash when your styler is heating up and will stop flashing once the target temperature is reached and it is ready to use.
- If you have delicate, fine, bleached or coloured hair, use the lower heat setting. For thicker hair, use the higher heat setting. We suggest when using for the first time you test the heat settings to ensure you’ve got the correct temperature for your hair type. Start on the lowest setting and increase the temperature as necessary.
- Ensure your hair is dry and combed through.
- Divide hair into sections.
- Please note: Before styling make sure the universal heat glove is worn on the hand which is wrapping the hair around the barrel.
- Pressing the lever, place the appliance midway up a section of hair and spread hair evenly between the lever and barrel.
- Once hair is in place carefully let go of the lever so the hair is held securely between lever and barrel. Gently slide the appliance down to the hair ends.
- Wind the hair around the barrel at a slight angle, so the hair wraps around the barrel in a spiral motion. As you wind the hair around the barrel, ensure the hair is distributed evenly so the entire section is touching the barrel, try not to overlay the hair
- Hold the end of the hair in place for 5-8 seconds, depending on your hair type. Then press the lever to release the section of hair and pull the appliance away.
- Repeat as necessary.
- Allow hair to cool before combing through.
- To switch off your styler please press and hold the on/off button for 2 seconds. The gentle notification sound indicates the styler has switched off.
- Allow to cool before storing away.